Difference between revisions of "Asphalt Shingles - Changes in Slope (Outside Angle)"
Difference between revisions of "Asphalt Shingles - Changes in Slope (Outside Angle)"
(→RELATED WORK BY OTHERS) |
|||
| Line 23: | Line 23: | ||
=== RELATED WORK BY OTHERS === | === RELATED WORK BY OTHERS === | ||
| − | ;(A) [[RoofStar Guarantee Standards for Asphalt | + | ;(A) [[RoofStar Guarantee Standards for Asphalt Shingle Systems#AShDECK|'''Acceptable Deck''']] |
</div><!-- COL-6-MD --> | </div><!-- COL-6-MD --> | ||
</div><!-- PANEL BODY --> | </div><!-- PANEL BODY --> | ||
Revision as of 21:00, 21 October 2019
| RoofStar Guarantee Standards are blue-linked |
Asphalt Shingle Details
1 WORK INCLUDED
- (1) Underlayment
- Underlayment on the upper slope must overlap the metal transition flashing and lower slope underlayment.
- (2) Self-adhered (eave protection) Membrane
- Optional for this slope change configuration, to seal the upper edge of the metal transition flashing. When installed, the SA membrane must overlap the metal by at least 50 mm (2”) and extend upslope past the edge of the lower slope underlayment by at least 50 mm (2”).
- (3) Metal Transition Flashing
- The lower leg must measure at least 100 mm (4”); the upper leg should measure at least 125 mm (5”).
- (4) Starter Shingle
- (5) Shingle
2 RELATED WORK BY OTHERS
- (A) Acceptable Deck
NOTE: Refer to RoofStar Guarantee Standards for additional requirements.
RoofStar Guarantee Standards for Asphalt Shingle Systems