Difference between revisions of "ASM Ridge (Unvented, Uninsulated)"

Revision as of 19:17, 10 August 2016

(1) Underlayment: The type of underlay required is determined by roof slope.
(2) Slip Sheet: Recommended over asphaltic underlays and / or as required by metal roof panel manufacturer.
(3) Architectural Metal Roof Panel: Turn up (bread panned) at termination and drag load fastened with compatible non-corrosive fasteners.
(4) 'Z' Closure: Set in accepted caulking and secured with compatible non-corrosive, flathead fasteners.; or
(5) Pre-formed Closure: Set in accepted caulking.
(6) Metal Cap Flashing: Joints overlapped 100 mm (4") minimum, sealed with two rows of accepted caulking. Exposed edges must be turned under 12.7 mm (1/2"). Fastened to each standing seam with high domed gasketed cladding screws or hooked to 'Z' closures.
(7) Drag-load Fasteners: Compatible non-corrosive fasteners.

NOTE: Refer to RoofStar Guarantee Standards for additional requirements.

@@ Line 3: / Line 3: @@
 === WORK INCLUDED ===
-;(1) [[RoofStar Guarantee Standards for ASM Roof Systems#ASMUNDERLAYMENT|'''Underlayment''']]: The type of underlay required is determined by roof slope (see Section 8.1.4.1 and Section 8.1.4.2).
+;(1) [[RoofStar Guarantee Standards for ASM Roof Systems#ASMUNDERLAYMENT|'''Underlayment''']]: The type of underlay required is determined by roof slope.
 ;(2) [[RoofStar Guarantee Standards for ASM Roof Systems#ASMSLIP|'''Slip Sheet''']]: Recommended over asphaltic underlays and / or as required by metal roof panel manufacturer.
 ;(3) [[RoofStar Guarantee Standards for ASM Roof Systems#ASMPANEL |'''Architectural Metal Roof Panel''']]: Turn up (bread panned) at termination and drag load fastened with compatible non-corrosive fasteners.