Search results

Create the page "Insulation" on this wiki! See also the search results found.

WP Details:F1.7.4 (Steel Deck - Substrate Overlay Board)
;(5) [[Grade-level Waterproofing Standard#WPINSULATION | '''Insulation''']]: Optional: Extruded, Expanded Polystyrene, Type 4, CAN/ULC-S701-97, co

4 KB (527 words) - 21:15, 7 September 2021
WP Details:F1.7.5 (Expansion Joint - Deck Level)
;(6) [[Grade-level Waterproofing Standard#WPINSULATION | '''Insulation''']]: Optional: Extruded, Expanded Polystyrene, Type 4, CAN/ULC-S701-97, co ...]: Synthetic permeable fabric required over extruded, expanded polystyrene insulation overburdened with pavers, growing mediums, sand and gravel beds for unit ma

4 KB (527 words) - 21:16, 7 September 2021
WP Details:F1.7.6 (Walls - Planter Pre-Curb Wall)
...oofing Standard#WPDECK | '''Plaza Deck Assembly''']]: Extruded polystyrene insulation and filter mat (optional) over primary waterproofing membrane. Concrete pav

5 KB (580 words) - 21:16, 7 September 2021
WP Details:F1.7.8 (Walls - Window Curb & Flashings)
;(3) [[Grade-level Waterproofing Standard#WPINSULATION | '''Insulation''']]: Extruded, Expanded Polystyrene, Type 4, CAN/ULC-S701-97, compressive ;(B) Supporting Curb: Height varies depending on the insulation thickness and type of waterproofing assembly.

4 KB (596 words) - 21:17, 7 September 2021
WP Details:F1.7.12 (Deck Drain - Unit Masonry on Pedestal Supports)
...ng Standard#WPINSULATION | '''Insulation''']]: Type 4 extruded polystyrene insulation ...paver pedestals designed to carry predicted live loads and accepted by the insulation manufacturer.

3 KB (413 words) - 21:22, 7 September 2021
SBS Canted Edge
;(2) [[SBS Roof Systems Standard#PART_7|'''Insulation''']]: Installed in staggered and offset layers (not illustrated), and secur ;(3) [[SBS Roof Systems Standard#PART_8|'''Insulation Overlay''']]: Subject to the requirements of Part 8 in the Standard.

3 KB (472 words) - 17:57, 27 October 2023
SBS Conventionally Insulated System (typical)
;(2) [[SBS Roof Systems Standard#PART_7|'''Insulation''']]: Installed in staggered and offset layers (not illustrated), and secur ;(3) [[SBS Roof Systems Standard#PART_8|'''Insulation Overlay''']]: Subject to the requirements of '''Part 8''' in the '''''RoofS

3 KB (446 words) - 17:36, 27 October 2023
SBS Protected Roof Assembly (typical)
...('''5''')('''4'''). In all other cases, a second drainage layer above the insulation is discretionary). Turn the drainage layer up at the perimeter to convey w ;(6) [[SBS Roof Systems Standard#PART_7|'''Insulation''']]: XPS insulation, ideally installed in multiple layers that are offset and staggered as illu

5 KB (661 words) - 17:37, 27 October 2023
SBS Structural Planter
;(7) '''Plaza Deck / Planter Interior Assembly''': Extruded polystyrene insulation and filter mat over primary roof membranes. Concrete pavers placed above pr

4 KB (513 words) - 18:21, 27 October 2023
Roof Maintenance
* Insulation to replace any wet materials discovered in cuts ...entrapped air or water, usually over decks with concrete fills or with wet insulation.</td>

75 KB (11,617 words) - 21:00, 3 September 2021
Glossary
...roofing materials and components, such as single-ply membranes, flashings, insulation boards, etc. Before adhesives are applied, their compatibility with other :Applying hot asphalt to what will be the concealed side of a material (insulation sheet, felt, etc.) before turning it over and arranging it in place.

76 KB (11,565 words) - 18:09, 26 January 2024
Bibliography
<u>RSI - Roofing / Siding / Insulation</u>. 7500 Old Oak Boulevard, Cleveland, OH 44130.

4 KB (548 words) - 14:32, 18 August 2023
Accepted Materials - EPDM Membrane Systems
===[[RoofStar Guarantee Standards for EPDM Membrane Systems#EPDMINSULATION | Insulation]] === :<big><big>Composite Board Insulation</big></big>

5 KB (633 words) - 20:30, 26 July 2021
Accepted Materials - TPO Membrane Systems
===[[RoofStar Guarantee Standards for TPO Membrane Systems#TPOINSULATION | Insulation]]=== :<big><big>Composite Board Insulation</big></big>

5 KB (614 words) - 20:30, 26 July 2021
ASM Introduction
...php?title=RoofStar_Guarantee_Standards_for_ASM_Roof_Assemblies#ASMINS '''5 Insulation'''] and [http://rpm.rcabc.org/index.php?title=RoofStar_Guarantee_Standards_

4 KB (582 words) - 21:35, 30 October 2017
Draft CD 17
;(2) [[SBS Roof Systems Standard#PART_7|<big>Insulation</big>]]: ;(3) [[SBS Roof Systems Standard#PART_8|<big>Insulation Overlay Panel</big>]]:

4 KB (584 words) - 15:27, 26 February 2024
Draft CD 21
;(2) [[TPO Roof Systems Standard#PART_7|<big>Insulation</big>]]: ;(3) [[TPO Roof Systems Standard#PART_8|<big>Insulation Overlay Panel</big>]]:

4 KB (599 words) - 22:20, 23 February 2024
Materials:Roofmate CT (Type 4)
ROOFMATE insulation is an extruded, expanded, foamed Type 4 CAN / ULC-S701-97 / CAN / CGSB-51.2

2 KB (255 words) - 18:34, 4 December 2019
Materials:Foamular C200 (Type 3)
...® insulation is specifically designed to provide high quality, economical insulation for conventional roofs, with single-ply, two-ply or four-ply roof membranes FOAMULAR® C200® insulation is an extruded, Type 3 CAN / ULC S701 polystyrene foam. It has excellent in

2 KB (252 words) - 21:36, 7 November 2016
Materials:Foamular F350 (Type 4)
FOAMULAR® F350 insulation is an extruded, Type 4 CAN/ULC-S701/CAN/CGSB-51.20-M87 polystyrene rigid bo

2 KB (264 words) - 21:37, 7 November 2016