Difference between revisions of "ASM Valley (Unhooked)"
Difference between revisions of "ASM Valley (Unhooked)"
(Created page with "File:8.1.4.6.1.jpg === WORK INCLUDED === (1) <b>Valley Protection Membrane</b>: Accepted self-adhered modified bituminous eave protection membrane. (2) <b>Underlayment...") |
|||
| Line 1: | Line 1: | ||
[[File:8.1.4.6.1.jpg]] | [[File:8.1.4.6.1.jpg]] | ||
| + | |||
=== WORK INCLUDED === | === WORK INCLUDED === | ||
| Line 18: | Line 19: | ||
(8) <b>Valley Panel Overlap: </b>Overlaps minimum 200 mm (8") sealed with two rows of accepted caulking and drag load fasteners. | (8) <b>Valley Panel Overlap: </b>Overlaps minimum 200 mm (8") sealed with two rows of accepted caulking and drag load fasteners. | ||
| + | |||
=== RELATED WORK BY OTHERS === | === RELATED WORK BY OTHERS === | ||
Revision as of 17:59, 21 December 2015
1 WORK INCLUDED
(1) Valley Protection Membrane: Accepted self-adhered modified bituminous eave protection membrane.
(2) Underlayment: The type of underlay required is determined by roof slope (see Section 8.1.4.1 and Section 8.1.4.2).
(3) Slip Sheet: Recommended over asphaltic underlays and / or as required by metal roof panel manufacturer.
(4) Valley Metal Panel: Preformed with centre rib.
(5) Metal Clip: Installed to metal roof panel manufacturer’s printed instructions.
(6) Pre-Formed Closures: Two rows set in accepted caulking.
(7) Architectural Metal Roof Panel
(8) Valley Panel Overlap: Overlaps minimum 200 mm (8") sealed with two rows of accepted caulking and drag load fasteners.
2 RELATED WORK BY OTHERS
(A) Acceptable Deck
NOTE: * Refer to RGC Guarantee Standards for additional requirements.