Difference between revisions of "LMF Metal Cap Flashing (joints)"

Jump to: navigation, search

Difference between revisions of "LMF Metal Cap Flashing (joints)"

Line 9: Line 9:
 
[[File:10.2.1.jpg|class=img-responsive]]
 
[[File:10.2.1.jpg|class=img-responsive]]
 
</div>
 
</div>
<div style="width:260px; float: left;">
+
<div style="width:270px; float: left;">
 
:[[File:G1.7.1 - Standing Seam Metal Clip.jpg|class=img-responsive]]  
 
:[[File:G1.7.1 - Standing Seam Metal Clip.jpg|class=img-responsive]]  
 
</div>
 
</div>

Revision as of 15:43, 16 November 2016

RoofStar Guarantee Standards are blue-linked
Metal Flashing Details

10.2.1.jpg

G1.7.1 - Standing Seam Metal Clip.jpg

G1.7.1 - Single S-Lock.jpg

END JOINTS in metal flashings are made using any one of the joints shown in this section, providing the following rules are complied with:

(1) Expansion: Allowances should be made for expansion and contraction. Soldered joints are not acceptable.

(2) Underlayment: Membrane under cap flashing. See, for example, SBS Roof Systems, 10.3 Application.

(3) Clips: Standing seams are fastened to wood blocking before applying the following length, using screws and clips.

(4) Fasteners: S-locks and Double S-locks are screwed through the single leaf before applying the following length. See SBS Roof Systems - 12. Perimeter Flashing: Metal.

(5) Metal Cap Flashing: Fastened with continuous concealed clips or cladding screws evenly spaced between seams. See SBS Roof Systems - 12. Perimeter Flashing: Metal.


Further detail on fastening of flashing is detailed in the SMACNA Manual referenced in Section 10.2.

NOTE: Refer to RoofStar Guarantee Standards for additional requirements.




Back to Metal Flashing Details

Back to Construction Details