Difference between revisions of "Materials:Retrofit Board"

Jump to: navigation, search

Difference between revisions of "Materials:Retrofit Board"

(Created page with "<i>Manufacturer:</i> <b>JOHNS MANVILLE CORPORATION</b> <i>Contact Address:</i> See Membership List, Section 1 <i>Product Group:</i> <b>PERLITIC ROOF INSULATION - RETRO-FIT B...")
 
Line 58: Line 58:
 
</tr>
 
</tr>
 
</table>
 
</table>
 +
 +
 +
 +
 +
[[Section:C. Accepted Materials|<i class="fa fa-chevron-circle-left fa-2x" ></i> Back to ''Accepted Materials'']]
 +
 +
 +
[[Main Page|Home]]

Revision as of 17:37, 20 June 2016

Manufacturer: JOHNS MANVILLE CORPORATION

Contact Address: See Membership List, Section 1

Product Group: PERLITIC ROOF INSULATION - RETRO-FIT BOARD

Country of Origin: USA

Country of Manufacture: USA

DESCRIPTION

The roofing assembly / material information published in the RCABC Roofing Practices Manual does NOT represent a complete set of the manufacturer’s data or specifications. The preparation of a detailed specification is the responsibility of the design authority.

Retro-Fit Board is a perlite-based utility board for use as a divorcing layer in reroofing and in new construction as a top layer in a multi-layer insulation system.

Half-inch Retro-Fit Board is a high density board made of expanded perlite and cellulosic fibres. It serves as an upgrade for wood fibre utility roofing products. The perlite particles are subjected to intense heat, which causes them to expand approximately fifteen times their original size.

The top surface is sealed with Top-Loc coating to ensure good attachment in bituminous applications. The minimum recycled content is 35% by weight.

Retro-Fit Board Insulation / Overlay

Thermal Resistance: RSI = .23 / 13 mm (R value = 1.32 / 1/2 inch)
Uses 13 mm (1/2") Retro-fit Board is a perlite-based utility board for use as a divorcing layer in reroofing and in new construction as a top layer in a multi-layer insulation system. It is not recommended for use directly over steel decks. It may be applied using hot bitumen and / or mechanical fasteners. It may be used as a primary or overlayment board.
Standards:
  • CSA A284-1976
  • CAN / CGSB 51.10-92
  • ASTM C 728
  • Factory Mutual Approved
  • Underwriters Laboratories Canada
Compressive Strength: CSA A284-1976 37 psi
Density: CSA A284-1976 13 pcf
Standard Sizes 0.6 m x 1.2 m
(24" x 48")
1.2 m x 1.2 m
(48" x 48")
1.2 m x 2.4 m
(48" x 96")
Thicknesses: 13 mm (½")



Back to Accepted Materials


Home