Roof Plans

Jump to: navigation, search

Roof Plans

Revision as of 15:59, 9 September 2021 by James Klassen (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)


Division E - General Information


Roof Plans

NOTICE TO READER: This is an information page only. To read the standards applicable to a particular Waterproofing or Water-shedding System, refer to the actual Standard located in Division B.

It is presumed that roofs are as important as floors, so there is no reason why detailed roof plans, as complete as floor plans, should not be made available. Roof plans should show the existence and location of all roof penetrations such as drains, vents, anchors, ventilators, etc. They should also show details of the roof system, roof edges, control joints, flashing, and they should provide all pertinent information relative to the construction desired. Experience shows that relatively few roof failures occur in the middle or main body of the roof. The majority of failures appear to occur where design detail is required. The design of such detail requires considerable study and knowledge and, all too frequently, the design is inadequate for the results required. This does not mean that the design is always at fault and the method of application is perfect. The methods of application will be covered in subsequent sections of this Manual.

To view design details that meet RoofStar Guarantee Standards, see Division D: Construction Details.

© RCABC 2024
No reproduction of this material, in whole or in part, is lawful without the expressed permission of the RCABC Guarantee Corp.