SBS Fall Protection Anchor in Roof

RoofStar Guarantee Standards are blue-linked

SBS Details

1 WORK INCLUDED

(1) Flashing

0.08 mm (0.032", 20 gauge) Aluminum or 0.56 mm (16 oz) copper to CSA B272-93 flashing supplied by anchor manufacturer with flanges sealed by roofer.

(2) Flashing Flange

minimum 100 mm (4") flange set in coating of compatible sealant.

(3) Primary Membrane and Membrane Flashing.

(4) Protected Membrane Roof Assembly

Flashing to extend a minimum 200 mm (8") above finished roof surface (pavers, ballast, or walkways). See [[RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies#SBSPMRAMEMBRANE | 12.1.3.2 Membranes for specific Application requirements.

(5) Conventional Roof Assembly

Flashing to extend a minimum 200 mm (8") above finished roof surface. See membrane flashing requirements under 10.3 Application.

(6) Insulation

See available insulation products in the Accepted Materials section of this Manual.

---

2 WORK BY OTHERS

(A) Acceptable Supporting Deck Structure

Concrete slab shown, see anchor manufacturer's attachment details for other deck types.

(B) Roof Anchor

Anchor selection and attachment details are the responsibility of the Design Authority

(C) Anchor Eye

(D) Water Tight Cap

NOTE: Refer to RoofStar Guarantee Standards for additional requirements.

---

Back to RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies

Back to SBS Modified Bitumen Construction Details

Back to Construction Details