Difference between revisions of "SBS Parapet-Wall Connection"

Revision as of 19:26, 6 December 2017

RoofStar Guarantee Standards are blue-linked

SBS Details

Click below for a printable version of this page.

(1) Gypsum Deck Overlay: If required by design authority.
(2) Vapour Retarder: If required by design authority.
(3) Insulation: See list of Accepted Materials.
(4) Insulation Overlay Board: As required.
(5) Primary Membrane and Membrane Protection
(6) Membrane Flashing (attachment & termination): Mechanically fasten at terminations. At least one ply must extend over outside edge.
(7) Metal Base Flashing: Optional on flexible membrane systems. Required on assemblies using gravel ballast filter mats.
(8) Metal Cap Flashing: Must overlap exterior wall finish. Fasten with concealed clip-type fasteners or cladding screws evenly spaced between seams.
(9) Wall Tie-in: Minimum 2 mm (0.078") self-adhered modified bitumen or flexible membrane manufacturers approved detail.
(10) Metal Counter-flashing

(A) Acceptable Deck
(B) Air/Vapour Seal
(C) Acceptable Wall Surface
(D) Wood Blocking
(E) Sloped Wood Blocking: Required over 100 mm (4") parapet width.
(F) Wall Sheathing Membrane: Minimum 1 mm (0.040") self-adhered modified bitumen.
(G) Wall Cladding

NOTE: Refer to RoofStar Guarantee Standards for additional requirements.

@@ Line 31: / Line 31: @@
 ;(6) [[RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies#SBSSTRIPTERM|'''Membrane Flashing (attachment & termination)''']]: Mechanically fasten at terminations.  At least one ply must extend over outside edge.
 ;(7) [[RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies#METALCAP-SBS|'''Metal Base Flashing''']]: Optional on flexible membrane systems. Required on assemblies using gravel ballast filter mats.
-;(8) [[RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies#METALCAP-SBS|'''Metal Cap Flashing''']]: Must overlap exterior wall finish.  </i>Fasten with  concealed clip-type fasteners  <b>or</b> cladding screws evenly spaced between seams.
+;(8) [[RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies#METALCAP-SBS|'''Metal Cap Flashing''']]: Must overlap exterior wall finish.  Fasten with  concealed clip-type fasteners  <b>or</b> cladding screws evenly spaced between seams.
 ;(9) [[RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies#SBSWALLTIEIN|'''Wall Tie-in''']]: Minimum 2 mm (0.078") self-adhered  modified bitumen or flexible membrane manufacturers approved detail.
 ;(10) [[RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies#METALCAP-SBS|'''Metal Counter-flashing''']]: