TS Details:E4.7.5 (Tile - Curb Flashing)

Jump to: navigation, search

TS Details:E4.7.5 (Tile - Curb Flashing)

Revision as of 21:08, 19 August 2016 by James Klassen (talk | contribs)

Curb flashings are applied around skylights, chimneys or other larger penetrations. The basic principle is to deflect the water rushing against the uproof side, safely around then on top of the tiles on the down roof side.

The recommended method is to use 3 lb. lead sheeting due to its malleability and, therefore, easy conformance to the tile’s contour.

Tile Roofing Details

7.3.2.2.17.jpg

Upper and lower flashings should be conformed with tile’s surface.

  • Upper flashings should extend 150 mm (6") past corners on each side, then formed around soakers.
  • Lower flashing should extend 100 mm (4") past corners and lapped under the soakers.


A mortar or mastic bedding should be applied to the tops of the concrete tile before flashing to prevent wind blown rain or vermin from entering.



Back to Slate Application

Back to Tile and Slate Construction Details

Back to Construction Details