SBS Basic Curb

RoofStar Guarantee Standards are blue-linked

SBS Details

Click below for a printable version of this page.

1 WORK INCLUDED

(1) Supporting Deck Overlay

Required when insulation is too thin to span flutes of steel decking or when required as thermal barrier by design authority.

(2) Air or Vapour Control Layers

If required by design authority.

(3) Insulation

Mechanically fastened. See available insulation products in the Accepted Materials section of this Manual.

(4) Insulation Overlay

Asphalt adhered or mechanically fastened. Two layers required over heat-sensitive insulation.

(5) Base Sheet

Adhered to overlay board using asphalt, cold adhesive, self-adhered, mechanical attachment or torch applied according to manufacturer’s specification and to RoofStar Guarantee Standards. Torching directly to wood surfaces is not permitted.

(6) Base Sheet Flashing

Adhered according to manufacturer’s specifications, using cold adhesive, self-adhered, or torch applied to cover boards, or mechanically attached membrane. Torching directly to wood surfaces is not permitted.

(7) Cap Sheet

Applied according to manufacturer’s printed instructions and to RoofStar Guarantee Standards.

(8) Cap Sheet Flashing

Applied according to manufacturer’s printed instructions and to RoofStar Guarantee Standards to top of curb.

(9) Metal Flashing

As required by RoofStar Guarantee Standards.

(10) Fire-stop Tape

Recommended.

---

2 RELATED WORK BY OTHERS

(A) Acceptable Supporting Deck Structure

(B) Air and Vapour Control Layer Seal

(C) Wood Blocking

Minimum 200 mm (8") in height. (See asphalt adhered or mechanically fastened. Two layers required over heat-sensitive insulation. Cant is optional).

NOTE: Refer to RoofStar Guarantee Standards for additional requirements.

---

Back to RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies

Back to SBS Modified Bitumen Construction Details

Back to Construction Details