SBS Control Joint (Roof Divider)

RoofStar Guarantee Standards are blue-linked

SBS Details

1 WORK INCLUDED

(1) Supporting Deck Overlay

If required by design authority.

(2) Air or Vapour Control Layers

If required by design authority.

(3) Insulation

See available insulation products in the Accepted Materials section of this Manual.

(4) Insulation Overlay

Where required.

(5) Primary Membrane and Membrane Protection

(6) Membrane Flashing

Lap over top and mechanically fasten.

(7) Base Metal Flashing

Mechanically fasten to top of wood blocking. Optional on flexible membrane systems. Required on assemblies using gravel ballast filter mats.

(8) Metal Cap Flashing

NOTE: (7) and (8) may be one piece.

---

2 RELATED WORK BY OTHERS

(A) Acceptable Supporting Deck Structure

(B) Control Joint Assembly

Required to separate new systems from existing roof systems and at dissimilar roof decks or on BUR assemblies over 45 m x 45 m (150’ x 150’). Primed where applicable. Slope top if wider than 100 mm (4").

(C) Existing Roof Assembly

If applicable. Prepared for application of membrane flashing at control joint.

NOTE: See the Standard for additional requirements.

---

Back to RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies

Back to SBS Modified Bitumen Construction Details

© RCABC 2024
RoofStar^TM is a registered Trademark of the RCABC.
No reproduction of this material, in whole or in part, is lawful without the expressed permission of the RCABC Guarantee Corp.

3 Accept Terms Of Use

We use cookies to enhance your browsing experience and analyze website traffic. By clicking "Agree" or continuing to browse our website, you consent to the use of cookies and agree to the Roofing Practices Manual Terms Of Use.

Agree