Difference between revisions of "ASM Eave Protection and Underlayment (Low Slopes)"
Difference between revisions of "ASM Eave Protection and Underlayment (Low Slopes)"
| Line 1: | Line 1: | ||
| + | <hr> | ||
[[File:8.1.4.2.1.jpg]] | [[File:8.1.4.2.1.jpg]] | ||
| Line 21: | Line 22: | ||
<hr> | <hr> | ||
| + | |||
| + | |||
| + | [[Section:E. Application: Steep Slope Roofs|<i class="fa fa-chevron-circle-left fa-2x" ></i> Back to ''ASM Application'']] | ||
| + | |||
| + | [[Architectural Sheet Metal Construction Details|<i class="fa fa-chevron-circle-left fa-2x" ></i> Back to ''ASM Construction Details'']] | ||
[[Section:G. Construction Details|<i class="fa fa-chevron-circle-left fa-2x" ></i> Back to ''Construction Details'']] | [[Section:G. Construction Details|<i class="fa fa-chevron-circle-left fa-2x" ></i> Back to ''Construction Details'']] | ||
Revision as of 22:41, 21 December 2015
1 WORK INCLUDED
- (1) Underlayment And Eave Protection
- One ply of self-adhered modified bituminous underlayment material. Lap 50 mm (2") minimum on sides and 100 mm (4") minimum on ends.
- (2) Edge Metal Flashing
- Installed to manufacturer’s printed instructions.
Note: This specification is applicable to slopes 1:6 (2" in 12") and greater.
2 RELATED WORK BY OTHERS
- (A) Acceptable Deck
NOTE: * Refer to RGC Guarantee Standards for additional requirements.