Difference between revisions of "SBS Parapet (Typical)"

Revision as of 15:01, 19 July 2016

1. Gypsum Board: If required by design authority.
2. Vapour Retarder: If required by design authority.
3. Insulation: See list of Accepted Materials.
4. Insulation Overlay Board: As required.
5. Primary Membrane and Membrane Protection
6. Membrane Flashing: Mechanically fasten to outside face of parapet blocking (D). At least one ply must extend over outside edge.
7. Metal Base Flashing: Optional on flexible membrane systems. Required on assemblies using gravel ballast filter mats.
8. Metal Cap Flashing: Flashings 1 and 2 may be one piece. Fasten with continuous concealed clip-type fasteners or cladding screws evenly spaced between seams.

NOTE: Refer to RGC Guarantee Standards for additional requirements.

@@ Line 23: / Line 23: @@
 ;(A) [[RoofStar Guarantee Standards for SBS Roof Systems#SBS-STEELDECK|'''Acceptable Steel Deck''']]
 ;(B) [[RoofStar Guarantee Standards for SBS Roof Systems#SBSVAPOUR|'''Air/Vapour Seal''']]
-;(C) <b>Acceptable Wall Surface</b>
+;(C) [[RoofStar Guarantee Standards for SBS Roof Systems#SBSWALLSUB|'''Acceptable Wall Surface''']]
-;(D) <b>Wood Blocking</b>
+;(D) [[RoofStar Guarantee Standards for SBS Roof Systems#SBSWOODBLOCKING|'''Wood Blocking''']]
-;(E) <b>Sloped Wood Blocking:</b> Required over 100 mm (4") parapet width. See <i>RGC Guarantee Standard A6.9</i>
+;(E) [[RoofStar Guarantee Standards for SBS Roof Systems#SBSSLOPEDWOODBLOCKING|'''Acceptable Wall Surface''']]
+:Required over 100 mm (4") parapet width.
-NOTE: Refer to <i>RGC Guarantee Standards</i> for additional requirements.]
+'''NOTE''': Refer to <i>RGC Guarantee Standards</i> for additional requirements.