Difference between revisions of "ASM Roof-Wall Connection (Head-wall, Vented)"
Difference between revisions of "ASM Roof-Wall Connection (Head-wall, Vented)"
(→RELATED WORK BY OTHERS) |
|||
| Line 35: | Line 35: | ||
(E) <b>Building Paper</b> | (E) <b>Building Paper</b> | ||
| − | NOTE: | + | |
| + | '''NOTE''': Refer to <i>RGC Guarantee Standards</i> for additional requirements. | ||
| + | |||
<hr> | <hr> | ||
| + | |||
Revision as of 18:57, 19 July 2016
1 WORK INCLUDED
(1) Underlayment: The type of underlay required is determined by roof slope (see Section 8.1.4.1 and Section 8.1.4.2).
(2) Slip Sheet: Recommended over asphaltic underlays and / or as required by metal roof panel manufacturer.
(3) Architectural Metal Roof Panel: Turned up (bread panned) at termination.
(4) Metal Roof Panel Clip: installed to metal roof manufacturer’s printed instructions
(5) ‘Z’ Closure: set in accepted caulking and secured with compatible, non-corrosive flat head fasteners.
(6) Manufactured plastic louvres:
(7) Exposed Fastener: High domed, gasketed cladding type screw compatible with metal roof panel (see Section 8.1.4.1 and 8.1.4.2).
(8) Metal Base Flashing: Must extend 200 mm (8") over metal roof panel. Lap joints must be sealed with two rows of accepted caulking. Exposed edges to be turned under.
2 RELATED WORK BY OTHERS
(A) Acceptable Deck
(B) Wood Nailer
(C) Free Vent Area
(D) Wall
(E) Building Paper
NOTE: Refer to RGC Guarantee Standards for additional requirements.