Difference between revisions of "SBS Equipment Sleeper"

Revision as of 20:44, 5 August 2016

(1) Gypsum Deck Overlay: If required by design authority.
(2) Vapour Retarder: If required by design authority.
(3) Insulation: See available insulation products in the Accepted Materials section of this Manual.
(4) Insulation Overlay Board: As required.
(5) Primary Membrane and Membrane Protection
(6) Membrane Flashing: Lap one ply from each side over top of sleeper (C) and mechanically fasten.
(7) Alternate Cap Flashing: May be used instead of lapping membrane flashing over sleeper.
(8) Metal Base Flashing: Mechanically fasten to top of wood blocking, standing seam at corners, optional on flexible membrane systems. Optional on flexible membrane systems. Required on assemblies using gravel ballast filter mats.
(9) Metal Cap Flashing: NOTE: (8) and (9) may be one piece.

(A) Acceptable Deck
(B) Air / Vapour Seal
(C) Wood Blocking/Sleeper: Minimum 150 mm (6") thick, minimum 100 mm (4") above finished roof surface.

NOTE: Refer to RoofStar Guarantee Standards for additional requirements.

Revision as of 19:23, 4 August 2016 (view source) James Klassen (talk \| contribs) (→‎WORK INCLUDED) ← Older edit		Revision as of 20:44, 5 August 2016 (view source) James Klassen (talk \| contribs) (→‎RELATED WORK BY OTHERS) Newer edit →
Line 21:		Line 21:


−	'''NOTE''': Refer to ~~<i>RGC~~ Guarantee Standards~~</i>~~ for additional requirements.	+	'''NOTE''': Refer to '''''RoofStar Guarantee Standards''''' for additional requirements.