Difference between revisions of "SBS Expansion Joint (Wall)"

Revision as of 18:37, 1 December 2016

RoofStar Guarantee Standards are blue-linked

SBS Details

Click below for a printable version of this page.

(1) Vapour Retarder: The requirement for a vapour retarder is determined by the design authority. Optional terminations.
(2) Insulation
(3) Insulation Overlay: Where required.
(4) Primary Membrane and Membrane Protection
(5) Membrane Flashing: Mechanically fasten to top of wood blocking.
(6) Membrane Counter-flashing: Flashing sealed to wall with compatible mastic.
(7) Metal Base Flashing: Mechanically fasten to top of wood blocking (C). Optional on flexible membrane systems. Required on assemblies using gravel ballast filter mats.
(8) Metal Counter-flashing: Into reglet approximately 30 mm (1¼") and caulked.
(9) Caulking
(10) Membrane Underlay: Minimum self-adhered modified bitumen membrane.
(11) Metal Cap Flashing: Must overlap exterior wall finish. Fasten with continuous concealed clip-type fasteners or cladding screws evenly spaced between seams.

(A) Acceptable Deck
(B) Air/Vapour Seal: Sealed to wall.
(C) Wood Blocking: Height to provide minimum 200 mm (8") above completed roof system, slope top edge.
(D) Flexible Insulation
(E) Reglet
(F) Sloped Wood Blocking

NOTE: Refer to RoofStar Guarantee Standards for additional requirements.

@@ Line 8: / Line 8: @@
 <div style="text-align:center; vertical-align:center">
 [[File:10.3.3.2.jpg|class=img-responsive]]
+</div>
+::Click below for a printable version of this page.
+<div style="width:150px; text-align: left;">
+:[[File:Pdf.png|100 px|link=http://rpm.rcabc.org/images/4/42/D1.7.4-2_SBS_Details_-_Counter-flashings_%26_Reglets_%28Deck_-_Unsupported%29.pdf]]
 </div>
 </div><!-- COL-MD-6 -->