EPDM Protected Roof Assembly (Typical)

RoofStar Guarantee Standards are blue-linked

EPDM Details

1 WORK INCLUDED

(1) Protection Mat

Provide protection between concrete deck and membrane with installation of manufacturer specified and RGC accepted protection mat or deck overlay boards.

(2) Single-ply Membrane

Installed according to manufacturer's instructions and RoofStar Guarantee Standards.

(3) Adhesive

Proprietary, installed according to manufacturer's instructions, usually brushed, rolled or sprayed.

(4) Membrane Lap

EPDM (thermoset) membrane may be joined using uncured tape or proprietary adhesive.

(5) Fasteners

Install according to manufacturer's instructions (style may vary depending on material type and manufacturer's specification). May vary from drawing.

(6) Membrane Flashing

Adhered according to manufacturer's printed specifications using proprietary adhesive. Must be carried to outside of parapet or minimum 200 mm (8") above finished roof surface. Adhered to primary membrane.

(7) Insulation

Mechanically attached. Installed according to RoofStar Guarantee Standards. See available insulation products in the Accepted Materials section of this Manual.

(8) Filter Fabric

Metal base flashing required.

(9) Metal Flashing

As required by RoofStar Guarantee Standards.

(10) Ballast

Gravel or concrete paving tiles.

(11) Parapet Flashing: As required by RoofStar Guarantee Standards.

---

2 RELATED WORK BY OTHERS

(A) Acceptable Deck

(B) Acceptable Parapet Surface

Surface must be smooth, dry and clean. Rough surface must be covered with treated plywood, to be determined by design authority or inspector or as required by manufacturer.

(C) Sloped Wood Blocking

NOTE: Refer to RoofStar Guarantee Standards for additional requirements.

---

RoofStar Guarantee Standards for EPDM Roof Assemblies

Back to EPDM Construction Details

Back to Construction Details