Difference between revisions of "SBS Parapet (Typical)"

Revision as of 14:44, 19 July 2016

1. Gypsum Board: If required by design authority.
2. Vapour Retarder: If required by design authority.
3. Insulation: See list of Accepted Materials.
4. Insulation Overlay Board: As required.
5. Primary Membrane and Membrane Protection
6. Membrane Flashing: Mechanically fasten to outside face of parapet blocking (D). At least one ply must extend over outside edge.
7. Metal Base Flashing: Optional on flexible membrane systems. Required on assemblies using gravel ballast filter mats.
8. Metal Cap Flashing: Flashings 1 and 2 may be one piece. Fasten with continuous concealed clip-type fasteners or cladding screws evenly spaced between seams.

(A) Acceptable Steel Deck
(B) Air / Vapour Seal
(C) Acceptable Wall Surface
(D) Wood Blocking
(E) Sloped Wood Blocking: Required over 100 mm (4") parapet width. See RGC Guarantee Standard A6.9

NOTE: Refer to RGC Guarantee Standards for additional requirements.]

@@ Line 21: / Line 21: @@
 === RELATED WORK BY OTHERS ===
-(A) <b>Acceptable Deck</b>
+;(A) [[RoofStar Guarantee Standards for SBS Roof Systems#SBS-STEELDECK|'''Acceptable Steel Deck''']]
+;(B) <b>Air / Vapour Seal</b>
-(B) <b>Air / Vapour Seal</b>
+;(C) <b>Acceptable Wall Surface</b>
+;(D) <b>Wood Blocking</b>
-(C) <b>Acceptable Wall Surface</b>
+;(E) <b>Sloped Wood Blocking:</b> Required over 100 mm (4") parapet width. See <i>RGC Guarantee Standard A6.9</i>
-(D) <b>Wood Blocking</b>
-(E) <b>Sloped Wood Blocking:</b> Required over 100 mm (4") parapet width. See <i>RGC Guarantee Standard A6.9</i>
 NOTE: Refer to <i>RGC Guarantee Standards</i> for additional requirements.]