Difference between revisions of "ASM 10.4.5 Ridge (Snap Seam, Notched and Vented)"
Difference between revisions of "ASM 10.4.5 Ridge (Snap Seam, Notched and Vented)"
(→WORK INCLUDED) |
|||
Line 1: | Line 1: | ||
+ | <hr> | ||
[[File:8.1.4.14.1.jpg]] | [[File:8.1.4.14.1.jpg]] | ||
Line 35: | Line 36: | ||
+ | |||
+ | [[Section:E. Application: Steep Slope Roofs|<i class="fa fa-chevron-circle-left fa-2x" ></i> Back to ''ASM Application'']] | ||
+ | |||
+ | [[Architectural Sheet Metal Construction Details|<i class="fa fa-chevron-circle-left fa-2x" ></i> Back to ''ASM Construction Details'']] | ||
[[Section:G. Construction Details|<i class="fa fa-chevron-circle-left fa-2x" ></i> Back to ''Construction Details'']] | [[Section:G. Construction Details|<i class="fa fa-chevron-circle-left fa-2x" ></i> Back to ''Construction Details'']] |
Revision as of 22:48, 21 December 2015
1 WORK INCLUDED
(1) Underlayment: The type of underlay required is determined by roof slope (see Section 8.1.4.1 and Section 8.1.4.2).
(2) Slip Sheet: Recommended over asphaltic underlays and / or as required by metal roof panel manufacturer.
(3) Architectural Metal Roof Panel: Turn up (bread panned) at termination and drag load fastened with compatible non-corrosive fasteners.
(4) Metal Roof Panel Clip: installed to metal roof manufacturer’s printed instructions
(5) ‘Z’ Closure: set in accepted caulking and secured with compatible, non-corrosive flat head fasteners.
(6) Manufactured plastic louvres:
(7) Exposed Fastener: High domed, gasketed cladding type screw compatible with metal roof panel (see Section 8.1.4.1 and 8.1.4.2).
(8) Metal Cap Flashing: Joints overlapped 100 mm (4") minimum, sealed with two rows of accepted caulking. Exposed edges must be turned under.
2 RELATED WORK BY OTHERS
(A) Acceptable Deck
(B) Wood Nailer
(C) Free Vent Area
NOTE: * Refer to RGC Guarantee Standards for additional requirements.