Difference between revisions of "ASM Roof-Wall Connection (Head-wall, Vented)"

Revision as of 19:18, 10 August 2016

(1) Underlayment: The type of underlay required is determined by roof slope.
(2) Slip Sheet: Recommended over asphaltic underlays and / or as required by metal roof panel manufacturer.
(3) Architectural Metal Roof Panel: Turned up (bread panned) at termination.
(4) Metal Panel Clip: installed to metal roof manufacturer’s printed instructions
(5) 'Z' Closure: set in accepted caulking and secured with compatible, non-corrosive flat head fasteners.
(6) Manufactured plastic louvres
(7) Exposed Fasteners: High domed, gasketed cladding type screw compatible with metal roof panel.
(8) Metal Base Flashing: Must extend 200 mm (8") over metal roof panel. Lap joints must be sealed with two rows of accepted caulking. Exposed edges to be turned under.

NOTE: Refer to RoofStar Guarantee Standards for additional requirements.

@@ Line 4: / Line 4: @@
 === WORK INCLUDED ===
-;(1) [[RoofStar Guarantee Standards for ASM Roof Systems#ASMUNDERLAYMENT|'''Underlayment''']]: The type of underlay required is determined by roof slope (see Section 8.1.4.1 and Section 8.1.4.2).
+;(1) [[RoofStar Guarantee Standards for ASM Roof Systems#ASMUNDERLAYMENT|'''Underlayment''']]: The type of underlay required is determined by roof slope.
 ;(2) [[RoofStar Guarantee Standards for ASM Roof Systems#ASMSLIP|'''Slip Sheet''']]: Recommended over asphaltic underlays and / or as required by metal roof panel manufacturer.
 ;(3) [[RoofStar Guarantee Standards for ASM Roof Systems#ASMPANEL |'''Architectural Metal Roof Panel''']] : Turned up (bread panned) at termination.