Linear Metal Flashing Details
Linear Metal Flashing Details
Revision as of 20:56, 19 July 2016 by James Klassen (talk | contribs)
The drawings contained within this section are intended to represent a variety of sheet metal flashing applications while remaining generic with regards to manufacturers’ specific application specifications. They do not represent all possible manufacturer application roof system designs. Consult manufacturers’ specifications and RoofStar Guarantee Standards to develop a system acceptable to both the manufacturer and RGC.
For further information about sheet metal flashing designs and requirements, see Metal Perimeter Flashing (SBS) or parallel sections for EPDM and TPO/PVC membranes, in the RoofStar Guarantee Standards.
- G1.7.1 Metal Flashings (Cap Flashings - Joint Ends)
- G1.7.2 Metal Flashings (Inside Parapet Corner)
- G1.7.3 Metal Flashings (Parapet-to-Wall Transition - Site Formed)
- NOTE: The following pages are currently under construction