EPDM Roof System Details
EPDM Roof System Details
Revision as of 20:47, 3 September 2021 by James Klassen (talk | contribs)
- Division D - Construction Details
- Construction Details for EPDM Membrane Roof Systems
Editor's note This page is currently under revision, as the details are renumbered and new details and printable detail pages are added. Continue to watch for further updates to the this page and the displayed links.
- The drawings contained within this section are intended to represent a variety of thermoset membrane roof system applications while remaining generic with regards to manufacturers’ specific application specifications. They do not represent all possible manufacturer application roof system designs. Consult manufacturers’ specifications and the Standard for EPDM Membrane Roof Systems to develop a system acceptable to both the manufacturer and the RoofStar Guarantee Program.
NOTE: 'PDF' shown after a file name below indicates a downloadable print sheet is available for Construction Details. Click on the detail link and look for the icon.
1 GENERAL
- EPDM 1.3.1-1 Conventionally Insulated System (mechanically attached)
- EPDM 1.3.1-2 Conventionally Insulated System (adhered)
- EPDM 1.3.1-3 Protected Membrane Roof Assembly (typical)
2 SUPPORTING STRUCTURES: Decks and Walls
3 SECURING the ROOF ASSEMBLY
4 MATERIALS
5 DECK and WALL OVERLAYS
6 AIR and VAPOUR CONTROLS
7 INSULATION
8 INSULATION OVERLAYS
9 FIELD MEMBRANE
10 PERIMETERS and WALLS
11 DRAINS and PENETRATIONS
12 PROTECTED MEMBRANES and OTHER DETAILS
13 METAL FLASHINGS
14 THE ROOF as a PLATFORM
Back to EPDM (Thermoset) Membrane Systems
© RCABC 2024
RoofStarTM is a registered Trademark of the RCABC.
No reproduction of this material, in whole or in part, is lawful without the expressed permission of the RCABC Guarantee Corp.