EPDM Details:D2.7.7-2 Strip-in Flashings (Two-part Cable)
EPDM Details:D2.7.7-2 Strip-in Flashings (Two-part Cable)
Revision as of 16:10, 21 September 2016 by James Klassen (talk | contribs)
| RoofStar Guarantee Standards are blue-linked |
EPDM Details
FOR USE WHEN DISCONNECT OF CABLES OR PIPES IS IMPRACTICAL
1 WORK INCLUDED
- 1) Gypsum Deck Overlay
- May be required depending on insulation thickness or when required as a thermal barrier by design authority.
- (2) Vapour Retarder
- If required by design authority.
- (3) Insulation
- Mechanically attached. Installed according to RoofStar Guarantee Standards. See available insulation products in the Accepted Materials section of this Manual.
- (4) Single-ply Membrane
- Installed according to manufacturer's instructions and RoofStar Guarantee Standards.
- (5) Mastic
- Compatible mastic or sealant.
- (6) Membrane Flashing
- Adhered according to manufacturer's printed specifications using proprietary adhesive. Thermoset membrane may be joined using uncured tape or proprietary adhesive (See Section 6.1).
2 RELATED WORK BY OTHERS
- (A) Acceptable Deck
- (B) Wood Blocking
- (C) Two Piece Flashing
- Assembled around protrusion, laid over compatible sealant on top of primary membrane. Mechanically fasten two components together and fasten flange to wood blocking or deck.
NOTE: Refer to RoofStar Guarantee Standards for additional requirements.