TPO Roof System Details

Jump to: navigation, search

TPO Roof System Details



Division D - Construction Details
Construction Details for TPO Membrane Roof Systems
TPO project (courtesy Carlisle Syntec).jpg
The drawings linked on this page are intended to represent a variety of TPO Membrane roof system applications while remaining generic with regards to manufacturers’ specific application specifications. They do not represent all possible manufacturer application roof system designs. Consult each manufacturer's specifications and the RoofStar Guarantee Standards to develop a system acceptable to both the manufacturer and the RoofStar Guarantee Program.
For further information about TPO Membrane System designs and requirements, see the Standard for TPO Membrane Roof Systems.

Part 1 - General

Permitted Roof Systems ( Article 1.1.3.1.)
  1. Conventionally Insulated System (Typical)
  2. Conventionally Insulated System (Alternate)
  3. Protected Roof Assembly (Typical)

Part 6 - Air and Vapour Controls

Continuity and Support ( Article 6.3.2.1.)
  1. Air and Vapour Controls (Field)


Part 10 - Perimeters and Walls

General Application ( Article 10.3.2.3.)
  1. Membrane Termination A
  2. Membrane Termination B
  3. Membrane Termination C
  4. Membrane Termination D
  5. Membrane Termination E
  6. Membrane Termination F
Low-profile Edges ( Article 10.3.4.2.)
  1. Metal Edge Termination

Part 11 - Drainage

Part 12 - Penetrations and Curbs

Part 13 - Linear Metal Flashing

See the separate page, Construction Details for Linear Metal Flashings.

Part 14 - The Roof as a Platform

Standard for TPO Membrane Roof Systems

Home

© RCABC 2024
RoofStarTM is a registered Trademark of the RCABC.
No reproduction of this material, in whole or in part, is lawful without the expressed permission of the RCABC Guarantee Corp.

Retrieved from "http://rpm.rcabc.org/index.php?title=TPO_Roof_System_Details&oldid=47345"