Difference between revisions of "LMF Metal Cap Flashing (joints)"

Jump to: navigation, search

Difference between revisions of "LMF Metal Cap Flashing (joints)"

Line 8: Line 8:
 
<div style="text-align:center; vertical-align:center">
 
<div style="text-align:center; vertical-align:center">
 
[[File:10.2.1.jpg|class=img-responsive]]
 
[[File:10.2.1.jpg|class=img-responsive]]
[[File:Standing Seam Metal Clip.jpg|230 px]]
+
</div>
[[File:Single S-Lock.jpg|400 px]]
+
<div style="width:200px; float: left;">
 +
[[File:G1.7.1 - Standing Seam Metal Clip.jpg|class=img-responsive]]  
 +
</div>
 +
<div style="width:380px; float: right;">
 +
[[File:G1.7.1 - Single S-Lock.jpg|class=img-responsive]]
 
</div>
 
</div>
 
</div><!-- COL-MD-6 -->
 
</div><!-- COL-MD-6 -->

Revision as of 15:33, 16 November 2016

RoofStar Guarantee Standards are blue-linked
Metal Flashing Details

10.2.1.jpg

G1.7.1 - Standing Seam Metal Clip.jpg

G1.7.1 - Single S-Lock.jpg

END JOINTS in metal flashings are made using any one of the joints shown in this section, providing the following rules are complied with:

(1) Expansion: Allowances should be made for expansion and contraction. Soldered joints are not acceptable.

(2) Underlayment: Membrane under cap flashing. See, for example, SBS Roof Systems, 10.3 Application.

(3) Clips: Standing seams are fastened to wood blocking before applying the following length, using screws and clips.

(4) Fasteners: S-locks and Double S-locks are screwed through the single leaf before applying the following length. See SBS Roof Systems - 12. Perimeter Flashing: Metal.

(5) Metal Cap Flashing: Fastened with continuous concealed clips or cladding screws evenly spaced between seams. See SBS Roof Systems - 12. Perimeter Flashing: Metal.


Further detail on fastening of flashing is detailed in the SMACNA Manual referenced in Section 10.2.

NOTE: Refer to RoofStar Guarantee Standards for additional requirements.




Back to Metal Flashing Details

Back to Construction Details