Difference between revisions of "SBS Fire Separation Joint"

Revision as of 16:24, 20 August 2019

RoofStar Guarantee Standards are blue-linked

SBS Details

(1) Supporting Deck Overlay: If required by design authority.
(2) Air or Vapour Control Layers: If required by design authority.
(3) Insulation: See available insulation products in the Accepted Materials section of this Manual.
(4) Insulation Overlay: Where required.
(5) Primary Membrane and Membrane Protection
(6) Membrane Flashing
(7) Membrane Counter Flashing
(8) Base Metal Flashing: Mechanically fasten to top of plywood backing. Optional on flexible membrane systems. Required on assemblies using gravel ballast filter mats.
(9) Metal Flashing / Cladding
(10) Secondary Metal Cap Flashing: Joints to be offset from Cap Flashing, OR Water Channeling Clip may be used (See inset in detail D1.7.19 Roof-Wall Transitions (Fire Separation Wall)), OR solder standing seam joints. Do NOT place combustible materials over top of firewall.
(11) Metal Cap Flashing: Standing seam joints required.

NOTE: Refer to RoofStar Guarantee Standards for additional requirements.

@@ Line 29: / Line 29: @@
 === RELATED WORK BY OTHERS ===
 ;(A) [[RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies#SBSDECKS|'''Acceptable Supporting Deck Structure''']]
-;(B) [[RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies#SBSWALLSUB|'''Acceptable Wall Surface (Plywood)''']]
+;(B) [[RoofStar Guarantee Standards for SBS Modified Bitumen Roof Assemblies#SBSWALLSUB|'''Acceptable Wall Surface''']]
 ;(C) '''Wood Blocking'''
 ;(D) '''Grouted Finish''': Sloped surface to promote drainage off cap flashing.