Difference between revisions of "TPO/PVC Introduction"

Jump to: navigation, search

Difference between revisions of "TPO/PVC Introduction"

(6.2.1 PVC (Polyvinyl Chloride))
Line 39: Line 39:
  
 
PVC membranes should be applied in conformance with CGSB 37-GP-55M 1979, “Application of Sheet Applied Flexible Polyvinyl Chloride Roof Membrane” and the membrane manufacturer’s printed instructions.
 
PVC membranes should be applied in conformance with CGSB 37-GP-55M 1979, “Application of Sheet Applied Flexible Polyvinyl Chloride Roof Membrane” and the membrane manufacturer’s printed instructions.
 +
 +
  
 
[[Section:D. Application: Low Slope Roofs|<i class="fa fa-chevron-circle-left fa-2x" ></i> Back to ''Application: Low Slopes'']]
 
[[Section:D. Application: Low Slope Roofs|<i class="fa fa-chevron-circle-left fa-2x" ></i> Back to ''Application: Low Slopes'']]

Revision as of 19:03, 4 January 2016

1 (PLASTOMERIC)

Thermoplastic materials are defined as polymers which soften when heated and harden when cooled. This process is repetitive provided the material is not heated above the point at which decomposition occurs. No cross-linking or vulcanization occurs. In addition to heat welding, some materials can be solvent welded. These welds develop bonding strengths equalling or surpassing the strength of the base materials.

Thermoplastics materials used for roof membranes include:

  • PVC (Polyvinyl Chloride)
  • EIP (Ethylene Interpolymers)
  • ECB (Ethylene Copolymer Bitumen)
  • TPO (Thermoplastic Polyolefins)
  • EPR (Ethylene Propylene Rubber)


2 6.2.1 PVC (Polyvinyl Chloride)

PVC is a thermoplastic material produced through the polymerization of vinyl chloride, resulting in a relatively hard, resinous material. This material is then formulated with compounds, such as plasticizers and stabilizers, depending on the physical properties required for end use. PVC formulations have been developed to suit numerous commercial and industrial applications.

PVC roof systems are single-ply membranes available either non-reinforced or reinforced with polyester fabric or glass fibres, and in thicknesses usually ranging from 1.2 mm to 2.0 mm, depending on the manufacturer. Non-reinforced PVC membranes may typically exhibit excessive shrinkage characteristics, thus their use is often discouraged. The membrane may be applied loose-laid and ballasted, mechanically fastened, or fully adhered. Seams are heat or chemically welded (see manufacturer’s requirements).

PVC membrane should conform to CGSB 37-GP-54M 1979, “Roofing and Waterproofing Membrane, Sheet Applied, Flexible, Polyvinyl Chloride” which lists two types of membrane, according to manufacture:

  • Type 1
non-reinforced
  • Type 2
reinforced

and four classes, according to end use:

  • Class A
non-exposed roofing
  • Class B
exposed roofing
  • Class C
waterproofing
  • Class D
flashing membrane asphalt compatible

This standard covers requirements such as “thickness, lap joint strength, permeability, tensile strength, elongation at break, low temperature flexibility, water absorption, resistance to accelerated weathering, dimensional change after stress relaxation, and cone penetration”

PVC membranes should be applied in conformance with CGSB 37-GP-55M 1979, “Application of Sheet Applied Flexible Polyvinyl Chloride Roof Membrane” and the membrane manufacturer’s printed instructions.


Back to Application: Low Slopes