Search results

Create the page "Section:E. Steep Slope Roofs" on this wiki! See also the search results found.

AS Details:E2.7.1 (Low Slope Shingle Application)
...ial. Lap 50 mm (2") minimum on sides and 150 mm (6") minimum on ends. (See Section 3.1.5 for a list of accepted eave protection and underlayment.) ...: Consists of same type shingles used for roof, applied tabs facing up the slope.

2 KB (260 words) - 22:52, 21 December 2015
AS Details:E2.7.11 (Counter-flashing - Diverter Flashing)
...b>: and the kick-out must be approximately 20-degree angle to the vertical slope. [[Section:E. Application: Steep Slope Roofs| Back to ''Asphalt Shingle

1 KB (196 words) - 22:57, 21 December 2015
(Draft) PVC Roof Systems Standard
...''''RoofStar 15-Year Guarantee''''' are listed in each relevant Part under Section 1. All '''''RoofStar 15-Year Guarantee''''' requirements must be read toge ==Section 1.1. Design==

416 KB (56,532 words) - 22:23, 5 April 2024
(Draft) EPDM Roof Systems Standard
...''''RoofStar 15-Year Guarantee''''' are listed in each relevant Part under Section 1. All '''''RoofStar 15-Year Guarantee''''' requirements must be read toge ==Section 1.1. Design==

424 KB (57,418 words) - 22:20, 5 April 2024
(Draft) TPO Roof Systems Standard
...''''RoofStar 15-Year Guarantee''''' are listed in each relevant Part under Section 1. All '''''RoofStar 15-Year Guarantee''''' requirements must be read toge ==Section 1.1. Design==

421 KB (57,062 words) - 22:20, 5 April 2024
(Draft) Hot Rubber Roof Systems Standard
...''''RoofStar 15-Year Guarantee''''' are listed in each relevant Part under Section 1. All '''''RoofStar 15-Year Guarantee''''' requirements must be read toge ==Section 1.1. Design==

296 KB (41,811 words) - 22:23, 5 April 2024
Design Considerations
This section deals with roof system design considerations. ...and [http://rpm.rcabc.org/index.php?title=Steep_Slope_Roofs '''Steep Slope Roofs'''] for specific roof covering material information.)

3 KB (386 words) - 15:33, 9 September 2021
Roof Decks
...e less than the percentage of slope provided by the insulation. A minimum slope of 1:50 (1/4" in 12") is strongly recommended. The exception is often drain ...inimum plywood or non-veneer (O.S.B or wafer board) deck thickness for low-slope roofing (i.e., membrane roofing) shall be a minimum 12.7 mm (1/2")and as in

20 KB (2,969 words) - 16:06, 9 September 2021
ASM Details:E1.7.17 (Copper Standing Seam Systems Eave & Gable Flashing)
...dards for architectural concealed fastener metal roofing systems (refer to Section 2.1.4 and 8.1.6.1). RGC Guarantee Standards for the application of copper m [[Section:E. Application: Steep Slope Roofs| Back to ''ASM Application'

3 KB (379 words) - 22:50, 21 December 2015
ASM Details:E1.7.18 (Zinc Standing Seam Systems Eave & Gable Flashing)
[[Section:E. Application: Steep Slope Roofs| Back to ''ASM Application' [[Section:G. Construction Details| Ba

3 KB (421 words) - 22:51, 21 December 2015
Roof Maintenance
This section has been reprinted with the kind permission of: Many of the remarks in this section pertain to bituminous built-up roofs. However, data is also included on flexible membrane (“non-convention

75 KB (11,617 words) - 21:00, 3 September 2021
Glossary
...ng ''deck'' structure (adapted from ''ASTM D6630-08 Standard Guide for Low slope Insulated Roof membrane Assembly Performance''). ...cle 3.1.3.4. in any of the waterproofing roof Standards for sheet membrane roofs, published in Division B of the RPM).

76 KB (11,565 words) - 18:09, 26 January 2024
Main Page Div
[[:Section:A. About|'''A. About''']] [[:Section:B. Essential Elements|'''B. Essential Elements''']]

7 KB (990 words) - 20:54, 2 August 2016
ASM Roof Systems Standard
...''''RoofStar 15-Year Guarantee''''' are listed in each relevant Part under Section 1. All '''''RoofStar 15-Year Guarantee''''' requirements must be read toge ==Section 1.1. Design==

260 KB (36,048 words) - 21:32, 5 April 2024
SBS Roof Systems Standard
...''''RoofStar 15-Year Guarantee''''' are listed in each relevant Part under Section 1. All '''''RoofStar 15-Year Guarantee''''' requirements must be read toge ==Section 1.1. Design==

465 KB (62,116 words) - 21:20, 5 April 2024
EPDM Roof Systems Standard
...''''RoofStar 15-Year Guarantee''''' are listed in each relevant Part under Section 1. All '''''RoofStar 15-Year Guarantee''''' requirements must be read toge ==Section 1.1. Design==

423 KB (57,312 words) - 21:21, 5 April 2024
TPO Roof Systems Standard
...''''RoofStar 15-Year Guarantee''''' are listed in each relevant Part under Section 1. All '''''RoofStar 15-Year Guarantee''''' requirements must be read toge ==Section 1.1. Design==

420 KB (56,956 words) - 21:23, 5 April 2024
PVC Roof Systems Standard
...''''RoofStar 15-Year Guarantee''''' are listed in each relevant Part under Section 1. All '''''RoofStar 15-Year Guarantee''''' requirements must be read toge ==Section 1.1. Design==

415 KB (56,426 words) - 21:31, 5 April 2024
Asphalt Shingle Systems Standard
==Section 1.1. Design== ...s an insulated or uninsulated ''roof system'', designed and constructed on roofs using a sheet or liquid-applied membrane, to exclude water. This type of '

235 KB (33,160 words) - 21:33, 5 April 2024
Hot Rubber Roof Systems Standard
...''''RoofStar 15-Year Guarantee''''' are listed in each relevant Part under Section 1. All '''''RoofStar 15-Year Guarantee''''' requirements must be read toge ==Section 1.1. Design==

294 KB (41,687 words) - 21:32, 5 April 2024