ASM Eave Protection and Underlayment (Low Slopes)
ASM Eave Protection and Underlayment (Low Slopes)
Revision as of 20:23, 7 September 2021 by James Klassen (talk | contribs)
Division D - Construction Details
ASM 8.1.2 Self-adhered Underlayment
| Notice to Reader | |
| Images used in a Construction Detail are representative and not prescriptive. Nor are they necessarily drawn to scale. Rather, they are provided to visually convey the requirements of the Standard they represent. Unless otherwise required by the Standard, dimensions, the selection of materials and their application remains the responsibility of the Design Authority. The full text of the referenced requirements in the Standard may be read by using the blue hyperlinks | |
ASM Details
- Click below for a printable version of this page (N/A)
1 WORK INCLUDED
- (1) Metal flashing underlayment/separation membrane
- required for metal flashings installed on wood substrates.
- (2) Metal edge flashing
- Installed to manufacturer's printed instructions.
- (3) Ice and water protection
- One ply of accepted self-adhered modified bituminous membrane.
- This application is required only for slopes less than 1:3 (4" in 12"). For slopes 1:3 or greater, see Construction Detail ASM 8.1.1 Eave Protection and Underlayment.
- Slip sheet not shown for clarity
2 RELATED WORK BY OTHERS
- (A) Acceptable deck
NOTE: See the Standard for additional requirements.
Back to ASM Roof System Details
© RCABC 2024
RoofStarTM is a registered Trademark of the RCABC.
No reproduction of this material, in whole or in part, is lawful without the expressed permission of the RCABC Guarantee Corp.