ASM Ridge (Unvented, Uninsulated)

1 WORK INCLUDED

(1) Underlayment

The type of underlay required is determined by roof slope (see Section 8.1.4.1 and Section 8.1.4.2).

(2) Slip Sheet

Recommended over asphaltic underlays and / or as required by metal roof panel manufacturer.

(3) Architectural Metal Roof Panel

Turn up (bread panned) at termination and drag load fastened with compatible non-corrosive fasteners.

(4) 'Z' Closure

Set in accepted caulking and secured with compatible non-corrosive, flathead fasteners.

or

(5) Pre-formed Closure

Set in accepted caulking.

(6) Metal Cap Flashing

Joints overlapped 100 mm (4") minimum, sealed with two rows of accepted caulking. Exposed edges must be turned under 12.7 mm (1/2"). Fastened to each standing seam with high domed gasketed cladding screws or hooked to 'Z' closures.

(7) Drag-load Fasteners

Compatible non-corrosive fasteners.

---

2 RELATED WORK BY OTHERS

(A) Acceptable Deck

(B) Wood Nailer

NOTE: Refer to RoofStar Guarantee Standards for additional requirements.

---

Back to ASM Application

Back to ASM Construction Details

Back to Construction Details