Difference between revisions of "Manufacturers:Siplast, Inc."

Revision as of 14:58, 25 June 2024

Division C - Accepted Materials

Siplast, Inc.
Associate Member (Manufacturer)

Materials Listed by Category The information published in the RCABC Roofing Practices Manual and offered below does NOT represent a complete set of the manufacturer’s data or specifications, nor is this material recommended or endorsed by the Guarantor. The preparation of a detailed specification is the responsibility of the Design Authority.
Website https://www.siplast.com/ Contact Address See the current Membership list and contact information at www.rcabc.org Country of Origin U.S.A. Country of Manufacture U.S.A. Year First Installed BC: 1978 Canada: 1978 Foreign: 1967
Notice and Disclaimer: Technical Data Sheets for SBS and APP Polymer-modified bituminous membranes Bituminous roofing membranes are governed by RGC Acceptance Criteria RGC ACWP-MOD (applicable to membranes accepted after July 1, 2023). The CSA Standard for these membranes, CSA A123.23 "Product specification for polymer modified bitumen sheet, prefabricated and reinforced", forms the backbone of the RGC Acceptance Criteria and has replaced the older CGSB Standard CGSB 37-GP-56M, which was withdrawn in 2015. The "British Columbia Building Code" (2024) references the CSA A123.23 Standard in both Part 5 and Part 9 of Division B. The Standard is also published in the National Building Code of Canada (2020), and the City of Vancouver Building Bylaw (2024). Not all manufacturers of SBS and APP polymer-modified membranes publish technical data sheets that fully align with the CSA Standard. Therefore, the reader must verify this information independently of the RGC, to the reader's own satisfaction. Consult the local manufacturer's representative through the "Find a Member" page on the RCABC association website.

Waterproofing Roofs

Insulation

Polyisocyanurate Foam

Paratherm CG

Lightweight Concrete

NVS Concrete

INSULCEL Concrete

Insulation Overlay Panels

High-density Insulation Overlays

Paratherm HD

Paratherm W HD

Bitumen (BUR)

PA-100 Mopping Asphalt (Type IV) (awaiting TDS)

PA-1000 Mopping Asphalt (Type IV)

SBS Polymer-Modified Bituminous Membranes

(See the membrane tables in Division C)

Base Sheets

Paratech 180 Base 3.0

Paratech 250 Base

Paratech 250 Base TG

Paratech Glass Base

Paratech Glass Base TG

Paratech Glass Base 3.0 TG

Base Sheets (Acceptable as a substrate for Parapro PMMA or self-adhered cap membranes)

Interplies

Waterproofing Roofs

SBS Polymer-Modified Bituminous Membranes (Cont.)

(See the membrane tables in Division C)

Cap Sheets

Paradiene 30 HT FR TG

Paradiene 30 HT TG

Paradiene 30 TG (Eco-Active)

Paradiene 30 TG

Paradiene 40 (awaiting TDS)

Parafor 30 TG (Eco-Active) (awaiting TDS)

Paratech 180 Cap FR TG

Paratech 250 Cap

Paratech 250 Cap TG

Paratech 250 Cap FR

Paratech 250 Cap FR TG

Paratech Glass Cap FR

Paratech Glass Cap FR TG

Teranap (1m x 8m)

Teranap 431 (2m x 20m)

Veral AL Polar White Spectra

Veral AL (Aluminum)

Veral SS

Single-ply Membranes

Parafor 50 LT

Parafor 50 TG

PVC Membranes

(See the membrane tables in Division C)

Parasolo PVC Smooth

Parasolo PVC Fleece-backed

Liquid Membrane Systems (Field Application)

(See the membrane tables in Division C)

ParaPro PMMA Roof Membrane Resin

Liquid Membrane Flashing Systems

(See the membrane tables in Division C)

Two-part Reinforced Liquid Membrane Flashing

Parapro 123 Flashing Resin

Waterproofing at Grade

SBS-Modified Bituminous Membranes

(See the membrane tables in Division C)

Base Sheets

Teranap 431 (2m x 20m)

Teranap (1m x 8m)

Cap Sheets

Teranap 431 (2m x 20m)

Teranap (1m x 8m)

Liquid Membrane Systems (Field Application)

(See the membrane tables in Division C)

ParaPro PMMA Roof Membrane Resin

Liquid Membrane Flashing Systems

(See the membrane tables in Division C)

Two-part Reinforced Liquid Membrane Flashing

Parapro 123 Flashing Resin

Water-shedding Roofs

Insulation Overlay Panels

High-density Insulation Overlays

Paratherm HD

Paratherm W HD

Underlayment/Eave Protection (Asphalt Shingles/Cedar/Tiles)

Self-adhered Materials

Paradiene 20 EG SA

Underlayment/Eave Protection (ASM)

Self-adhered Materials

Paradiene 20 EG SA

Accessories

An Accessory is a material that joins Primary or Secondary Materials together, or is connected to/with a Primary or Secondary material, but does not by its nature (apart from its installation) directly affect the water or wind resistance of the Waterproofing or Water-shedding system. An Accessory is not an Accepted Material and therefore the RoofStar Guarantee does not extend to cover any potential material or installation failure. Accessories are listed in the Roofing Practices Manual merely for reference to specifiers, designers and installers.

Paracoat Roof Coating

Home

© RCABC 2024
No reproduction of this material, in whole or in part, is lawful without the expressed permission of the RCABC Guarantee Corp.

@@ Line 60: / Line 60: @@
 ====SBS Polymer-Modified Bituminous Membranes====
 (See the membrane tables in [https://rpm.rcabc.org/index.php?title=Materials_by_Product_Category Division C])
 :'''Base Sheets'''
 :[[Materials:Irex 40 | {{hilite | Irex 40 || 2023-October-28 }}]]
@@ Line 114: / Line 115: @@
 ====SBS Polymer-Modified Bituminous Membranes (Cont.)====
+(See the membrane tables in [https://rpm.rcabc.org/index.php?title=Materials_by_Product_Category Division C])
 :'''Cap Sheets'''
 :[[Materials:Paradiene 30 |Paradiene 30]]
@@ Line 161: / Line 164: @@
 ====PVC Membranes====
 (See the membrane tables in [https://rpm.rcabc.org/index.php?title=Materials_by_Product_Category Division C])
 :[[Materials:Parasolo PVC Smooth | {{hilite | Parasolo PVC Smooth || 2024-January-31 }}]]
 :[[Materials:Parasolo PVC Fleece-backed | {{hilite | Parasolo PVC Fleece-backed || 2024-January-31 }}]]
 ====Liquid Membrane Systems (Field Application)====
+(See the membrane tables in [https://rpm.rcabc.org/index.php?title=Materials_by_Product_Category Division C])
 :[[Materials:ParaPro PMMA Roof Membrane Resin|ParaPro PMMA Roof Membrane Resin]]
 ====Liquid Membrane Flashing Systems====
+(See the membrane tables in [https://rpm.rcabc.org/index.php?title=Materials_by_Product_Category Division C])
 '''Two-part Reinforced Liquid Membrane Flashing'''
 :[[Materials:Parapro 123 Flashing Resin |Parapro 123 Flashing Resin]]
@@ Line 178: / Line 186: @@
 ====SBS-Modified Bituminous Membranes====
 (See the membrane tables in [https://rpm.rcabc.org/index.php?title=Materials_by_Product_Category Division C])
 :'''Base Sheets'''
 :[[Materials:Teranap 431 (2m x 20m) |Teranap 431 (2m x 20m)]]
@@ Line 187: / Line 196: @@
 ====Liquid Membrane Systems (Field Application)====
+(See the membrane tables in [https://rpm.rcabc.org/index.php?title=Materials_by_Product_Category Division C])
 :[[Materials:ParaPro PMMA Roof Membrane Resin|ParaPro PMMA Roof Membrane Resin]]
 ====Liquid Membrane Flashing Systems====
+(See the membrane tables in [https://rpm.rcabc.org/index.php?title=Materials_by_Product_Category Division C])
 '''Two-part Reinforced Liquid Membrane Flashing'''
 :[[Materials:Parapro 123 Flashing Resin |Parapro 123 Flashing Resin]]

Difference between revisions of "Manufacturers:Siplast, Inc."

Difference between revisions of "Manufacturers:Siplast, Inc."

Revision as of 14:58, 25 June 2024

Insulation

Insulation Overlay Panels

Bitumen (BUR)

SBS Polymer-Modified Bituminous Membranes

SBS Polymer-Modified Bituminous Membranes (Cont.)

PVC Membranes

Liquid Membrane Systems (Field Application)

Liquid Membrane Flashing Systems

SBS-Modified Bituminous Membranes

Liquid Membrane Systems (Field Application)

Liquid Membrane Flashing Systems

Insulation Overlay Panels

Underlayment/Eave Protection (Asphalt Shingles/Cedar/Tiles)

Underlayment/Eave Protection (ASM)

Accessories

Accept Terms Of Use